Robot Bending Machine Manufacturer: Introduction of Workflow of Robot Bending Machine

2020-08-03

robot bending machine workflow:

　　1.Robot bending machineFeeding

The robot grabs the product at the loading position, and whether to grab the product is mainly detected by the sensor on the fixture;

2. Positioning the middle stage

The robot places the product grasped from the loading position of the table and slides down to the lower height of the table under the action of gravity. The robot bender grabs the product again, ensuring consistency in each grab.Robot bending machine manufacturers

3. Robot-assisted bending

The robot moves the product close to the rear positioning device of the bending machine. During the approach, the robot slides along the lower die. When the rear positioning sensor is triggered, the product is in place and the robot controls the bending machine to bend.

4. Robot bending machine to replace the side and fixture

The robot places one side of the bent workpiece on the frame of the handheld table, and rotates the fixture 180 degrees to re-grab the workpiece.

5. Robot bending machine assists in bending the other side of the workpiece

　　6.Robot bending machinedischarge

After the finished product is palletized by the robot, the robot returns to the origin for a second work cycle.

Precautions for installation of uncoiling leveling line

Robot bending machine manufacturer: how to reduce the setting time of robot bending machine?

2020

08-03

Classification:

Industry Information

RELATED INFORMATION