The shearing machine manufacturer tells you the operation specification and maintenance method of the shearing machine

2020-10-22

plate shearing machineMainly used for cutting some hard plates, with good use efficiency. When using, please pay attention to its safe operation procedures and operate in accordance with certain requirements to avoid problems. In addition, the maintenance of its hydraulic system is also a very important step to ensure the normal operation of the equipment. So not very understandingplate shearing machineDear friends of operation and maintenance, look here!

plate shearing machineWhat is the operating procedure?
1. The operator must be familiar with the overall structure and performance of the equipment, and it is strictly forbidden to use equipment with excessive performance.
2. Before starting, please add grease in accordance with the equipment lubrication regulations, and check whether the foot switch and circuit are damaged. After turning on the machine, please check whether the machine has abnormal noise before use, and check whether the electrical control operation is normal.
3. Before working, the upper and lower blades should be set. The blade clearance should be determined according to the thickness of the cut steel plate, usually between 5-7% of the thickness of the cut steel plate. Each time the gap is adjusted, the upper and lower blades should reciprocate. Exercise once and check if the gap is suitable.
4. According to the requirements of the workpiece to be cut, adjust the size and position of the positioning plug. Before work, you should try to run it dry 2-3 times to ensure good lubrication and no abnormal operation before you can work.
5. It is forbidden to hit the blade with hard objects. When adjusting the blade gap, please stop the machine before continuing the operation. During the work process, it is strictly forbidden to put your hands on the cutting area or pick up the materials by hand. It is strictly forbidden for two people to cut two pieces at the same time on the same machine, and no one is allowed to standplate shearing machineBack.
6. The edge of the blade must remain sharp. If damage, wear or dullness is found, it should be sharpened or replaced in time.
7. When cutting thin sheets of different thicknesses and materials, the pressure of the leaf spring and the blade gap should be appropriately adjusted to prevent the spring from breaking or damaging the blade.
8. It is forbidden to cut steel bars, and it is forbidden to place other items on the workbench to avoid entering the cutting edge and damaging the blade.

How to maintainplate shearing machineThe hydraulic system?
1. The hydraulic circuit regularly checks the oil level of the oil tank. If the oil level is lower than the center line of the oil mark, it should be supplemented. After 500 hours of formal use of the machine, the hydraulic oil needs to be replaced, and every 2000 hours of use, the hydraulic oil needs to be replaced. The hydraulic oil used must meet the standard requirements, and the oil tank must be thoroughly cleaned every time the oil is changed.
2. The oil filter should be cleaned regularly, and solutions such as gasoline or trichloroethylene can be used. When using the machine for the first time, it should be cleaned after 8 days of use and every 30 days of work. In addition, if the oil filter component is severely damaged, it cannot be used and should be replaced immediately.
3. Check mechanical parts. All fasteners should be checked once a week, mainly to check for looseness, but also to check for lubrication and wear. If there is any abnormality, it should be handled in time and can be used after treatment.