CNC shearing machine operation matters needing attention and maintenance

2021-04-25

Precautions for the operation of CNC shearing machine:

1. The machine tool is suitable for shearing various steel plates, copper plates, aluminum plates and non-metallic materials with the thickness of the material rated for the machine tool, and must be materials without hard marks, welding slag, slag inclusion and welding seam, and over-thickness is not allowed.
2. When picking and placing products, it should be carried out after rising and stabilizing. Pay attention to the hand injury when the tool slides down.
3. It is not allowed to cut laminated sheets, trim the edges of raw edge sheets, and cut narrow sheets and short sheets that are not tightly pressed.
4. The cutting edge of the knife plate should be kept sharp. If the cutting edge becomes blunt or cracks, it should be replaced in time.
5. When shearing, the pressing device should firmly press the plate, and it is not allowed to shear under the condition of not being pressed tightly.
6. The equipment must be completely powered off before maintenance.
7. Clean up the oil around the equipment in time to prevent slipping.
8. It is forbidden to use percussion to tighten the stop device or adjust the blade gap. When adjusting the guide rail gap and blade gap, it should be stopped before it can be carried out. It is forbidden to enter the shearing area by hand or pick up and pick up materials by hand during working operation.

maintenance of cnc shearing machine:

1. Clean and clean the inside and outside of the machine before starting up every day to ensure that there are no debris and oil stains.
2. Check for oil leakage every day.
3. Lubricate the machine before starting up every day.
4. Always check whether the bolts and parts of the machine are loose, damaged or displaced, and tighten and repair them in time.