Blog
—
Yellowstone bending machine some work flow analysis!
2020-09-21
Yellowstone Bending MachineIt is widely used in some processing plants. This type of bending machine can be seen in many production lines. There are many kinds of bending machines. Therefore, let's take a look at its working process,Yellowstone Bending Machine.
(1) Before work
Before the operation of the bending machine, it is necessary to use manual brake to go through a working process to ensure that everything is normal before the machine and equipment can be opened. Then make a very detailed inspection of the shearing machine, then open the valve and release the gas in the system,Yellowstone Bending Machine.
2. When working
When the bending machine does a good job, it is not necessary to stack the sheet metal or cut the burr. The bottom plate should be firmly and firmly, and the surfaces of the left and right knives should be kept parallel. When cutting, can not be done in the case of pressure is not tight, cutting work must pay attention to the balance of the saw blade and firm,Yellowstone Bending Machine.
3. After work
After the bending machine is finished, the control switch should be closed, and then check whether the fully closed valve must be fully closed, and drop the upper knife plate in the direction of the bottom end,Yellowstone Bending Machine.
Through the detailed introduction can be seen,Yellowstone Bending MachineThe application workflow is actually very simple, but in the whole process of work, we must pay attention to the corresponding potential safety hazards, including the safety of the working technicians. We should wear safety helmets at work to prevent the show from being injured in the equipment, and we must fully close the control switch after the application is completed.
2020
/
09-21
Classification:
Industry Information
RELATED INFORMATION
Welcome to inquire
+86-714-6355458
Contact E-mail: sales@ysd-hd.com
Address: No. 158 Jinshan Avenue, Economic Development Zone, Huangshi City, Hubei Province
Copyright © Hubei Tri-Ring Metalforming Equipment Co.,Ltd
This website supports IPV4 / IPV6 bidirectional access